Microsoft Defender for Identity
Identity protection

Active Directory Federation Services

In brief

The procedure now directs administrators to Settings > Identities > On-premises > Sensor Management in the Microsoft Defender portal, then to open the sensor row actions menu and select Settings.

What Defender admins need to know

Use the updated portal path and sensor menu when following this validation procedure.

Summaries are generated from the documentation change itself.

Documentation change

The comparison below shows only the changed extract. Use the full-page view for complete context.

During the sensor installation on an AD FS, AD CS, or Microsoft Entra Connect server, the closest domain controller is automatically selected. Use the following steps to check or modify the selected domain controller:

  1. In the Microsoft Defender portal, go to Settings > Identities > SensorsOn-premises > Sensor Management to view all of your Defender for Identity sensors.

  2. Locate and select the sensor that you installed on the server.server, open its row actions menu, and select Settings.

  3. On the pane that opens, in the Domain controller (FQDN) box, enter the fully qualified domain name (FQDN) of the resolver domain controllers. Select + Add to add the FQDN, and then select Save.

    Screenshot of Defender for Identity sensor settings pane showing the Domain controller (FQDN) field where you enter the resolver domain controller for an AD FS sensor.

  4. Check that the Azure Advanced Threat Protection sensor service is running. After you save the Defender for Identity sensor settings, it might take a few seconds for the service to start.

  5. If the service doesn't start, review the Microsoft.Tri.sensor-Errors.log file, located by default at %programfiles%\Azure Advanced Threat Protection sensor\Version X\Logs.

  6. Use AD FS or AD CS to authenticate a user to any application, and then verify that Microsoft Defender for Identity observed the authentication.

    For example, select Hunting > Advanced Hunting. On the Query pane, enter and run one of the following queries: